Cast Seven Years' War semi-flat 40mm scale Artillery Aligner and Crewman with ram-rod with interchangeable heads. Cannon mould sold separately. Includes 2 PTFE rods.
Difficulty Levels 1 to 5:
Use 4 clamps instead of two (or use more elastic bands than normal). Space the clamps on the upper and lower quarters of each side of the mould when securing the mould. Venting should only be needed if you are not using Model Metal.
When venting you may need to drill a 1.5 mm hole through the mould at certain points. On the reverse side of the mould (the plain side) where the hole comes out you can add a channel upwards if you choose to, but as long as you have placed the rough side of the support board against the mould the air should be able to escape safely.
We recommend our scalpels because you need an extremely sharp blade to properly vent a mould.
Mould 3119 Artillery: Aligner and Crewman with ram-rod.
All the artillerymen are shown in shirt-sleeves and the same
will be used for Prussians, Austrians and Russians.
Only the heads will vary.
For Austrian crewmen use heads 3118/2 or 3118/7.
For Prussian crewmen use 3118/6.
For Prussian bombardiers (using howitzers) use 3119/2 or 3119/4.
For Russian artillery crewmen use 3118/6 or 3119/7.
For Russian bombardiers (using howitzers) use 3118/3.
Artillery: Assembly Guide (pdf).
Figures painted by Richard Hattersley.
This product is not suitable for children under the age of 14.
It was the first truly international war that changed the cour...
This is one of the 80-1 54mm Napoleonic moulds. There are some...
Sorry about the delay I went home to visit family. Also, than...